Kézzel készített Buzzblaster fuzz

Description

huen
Sage Solid Walnut Germanium Fuzz Pedal

Completely handmade, primarily using hand tools. Barely used.

Inside, it features the classic Burns Buzzaround fuzz circuit. Built on a turretboard with high-quality components (Carling footswitch, Switchcraft jack inputs, 24mm ˝Marshall˝ potentiometers—built to last a lifetime).

It runs on two NOS Russian and one Tungsram AC125 germanium transistor.

The enclosure is routed from a single piece of solid american walnut and covered with copper foil on the inside for shielding. Key signal paths use shielded cables. The back plate is made of 2mm steel.



⚠ WARNING: This pedal operates with positive ground. It is highly recommended to use it with a battery (since there is no LED, power consumption is minimal, just a few mA, meaning a single battery can last for years).

It can also be powered by an external 9V PSU, but must be connected to an isolated power supply or have a dedicated power adapter. It cannot be used in a daisy chain setup with other pedals, as this may cause damage to both the pedal and the power supply.