Castone electronic Castone CPA-1200B power amplifier

Description

huendeskes
The power amplifier shown in the picture is for sale in good condition.

Technical specifications
· Product-specific data
· Load impedance (stereo mode) 4-16 Ohm
· Load impedance (BRIDGE mode) 8-16 Ohm
· Rated output power (4 Ohm) 2× 600 W
· Rated output power (8 Ohm) 2× 450 W
· Music output power (4 ohm) 2× 700 W
· Music output power (8 ohm) 2× 540 W
· Rated output power (8 Ohm, bridge) 1× 1200 W
· Frequency response (-3dB cutoff) 5 Hz - 45 kHz
· Distortion factor (4 ohm) 0.03 %
· Signal-to-noise ratio min. 100 dB
· Balanced input
· Input sensitivity 900 mV
· Input impedance 20 kOhm
· Damping factor 250

General data
· Physical dimensions (rack) 19˝ RACK 3U front panel
· Physical dimensions (W x H x D) 482 × 132 × 415 mm
· Weight 19 kg
· Rated power consumption max. 2000 VA
· Mains voltage 230 V
Front panel:
· MAINS Power switch
· On LED indicating power on
· READY LED indicating ready state
· CLIP LED indicating maximum output voltage
· BRIDGE LED indicating Bridge mode
· LEVEL ch A Channel A volume control
· LEVEL ch B Channel B volume control

Rear panel:
· INPUTS A (BRIDGE) Input connector (6.3˝ JACK, XLR) for stereo and bridge mode
· INPUTS B Input connector (6.3˝ JACK, XLR) for stereo mode
· OUTPUT A (BRIDGE) Speaker output connector (4-pin SPEAKON) for stereo and bridge mode
· OUTPUT B Speaker output connector (4-pin SPEAKON) for stereo mode
· 230V 50/60Hz Mains connector
· ON-GROUND-OFF Switch to prevent ground loops
· STER. - BRID. Stereo/Bridge mode switch